Pilot's Guide

190-009663-02 Rev. B Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT/GTi 101
AUDIO PANEL AND CNS
1
NAV VOL/ID Knob –ControlsNAVaudiovolumelevel.PresstoturntheMorsecodeidentieraudioon
andoff.VolumelevelisshownintheNAVfrequencyeldasapercentage.
2
NAV Frequency Transfer Key –TransfersthestandbyandactiveNAVfrequencies.
3
NAV Knob –TunesthestandbyfrequenciesfortheNAVreceiver(large knob for MHz; small knob for kHz).
Presstomovethefrequencyselectedfortuning(lightbluenumbers)andtheFrequencyTransferArrow
betweenNAV1andNAV2.
4
NAV Frequency Box –DisplaysNAVstandbyandactivefrequencyelds,volume,andstationID.The
frequencyoftheNAVradioselectedfornavigationisdisplayedingreen.
5
COM Frequency Box –DisplaysCOMstandbyandactivefrequencyeldsandvolume.TheselectedCOM
transceiver frequency is displayed in green.
6
COM Knob – Tunes the standby frequencies for the COM transceiver (large knob for MHz; small knob for
kHz).Presstomovethefrrequencyselectedfortuning(lightbluenumbers)andtheFrequencyTransfer
ArrowbetweenCOM1andCOM2.
7
COM Frequency Transfer Key – Transfers the standby and active COM frequencies. Press and hold this key
fortwosecondstotunetheemergencyfrequency(121.500MHz)automaticallyintotheactivefrequency
eld.
8
COM VOL/SQ Knob – Controls COM audio volume level. Press to turn the COM automatic squelch on
andoff.VolumelevelisshownintheCOMfrequencyeldasapercentage.
9
DME Tuning Window –DisplaysDMEfrequencypairingmode.DisplaybyselectingDME Softkey.
10
ENT Key –ValidatesorconrmsDMEpairingmodeandAuto-tuneselection.
11
FMS Knob –FlightManagementSystemKnob,usedtoentertranspondercodes,selectDMEmodes,and
Auto-tuneentrieswhenDMETuningWindoworNRSTWindowispresent.PresstheFMS Knob to turn
the selection cursor on and off. The large knob moves the cursor in the window. The small knob selects
individual characters for the highlighted cursor location.
12
Transponder Data Box –Indicatestheselectedtranspondercode,operatingmode,reply,andidentstatus
for the applicable transponder.