Manualshelf

System Maintenance Manual

ManualsBrandsGarmin ManualsFlight DecksGarmin MDL Rev 5, SA01535Wi_D
111112113114115116117118119120
Page 4-28 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 2 190-00716-01
25. Hold the elevator in the neutral position, press the HDG and ALT buttons on the mode controller and
center the heading bug.
26. Engage the autopilot and turn the heading knob to set the heading bug to the right of center. Hold the
control yoke centered for approximately 10 seconds. Verify that the amber AIL→ annunciator is
displayed on both PFD 1 and PFD 2.
27. Turn the heading knob to set the heading bug to the left of center. Hold the control yoke centered for
approximately 10 seconds. Verify that the amber ←AIL annunciator is displayed on both PFD 1 and
PFD 2.
28. Disengage the autopilot and clear all modes.
29. Ensure the aircraft is on the ground and the nose wheel is approximately straight.
30. Engage the yaw damper and apply firm load on the right rudder pedal for approximately 20 seconds.
31. Verify that the amber ←RUD annunciator is displayed on both PFD 1 and PFD 2.
32. Apply firm load on the left rudder pedal for approximately 20 seconds.
33. Verify that the amber RUD→ annunciator is displayed on both PFD 1 and PFD 2.
34. Disengage autopilot.
35. The Trim Annunciator Check is complete.