FAA Approved Airplane Flight Manual Supplement

190-00716-03 Rev. 3 Hawker Beechcraft B300 and B300C King Air
FAA APPROVED Page 83 of 139
If Flying Vectors-To-Final:
3. Airplane on Vectors-To-Final
a. Mode Control Panel .................................................. PRESS HDG to fly ATC radar vectors
b. PROC button on PFDs or GCU ......................SELECT ‘ACTIVATE VECTORS-TO-FINAL’
NOTE
SUSP may annunciate on the HSI when Vectors-To-Final is selected. The flight plan will
automatically unsuspend when the airplane intercepts and turns inbound on the final
approach course. When automatic flight plan waypoint sequencing resumes, SUSP will
extinguish.
c. HSI CDI ......................................................... VERIFY CDI automatically changes to LOC
Course pointer slews to the front course
d. Pathways ......................................................................................................... AS DESIRED
e. Mode Control Panel ........................................................... PRESS NAV, verify LOC armed
Pressing the NAV button will arm the autopilot / flight director to capture Localizer and
prevent Glideslope from arming or capturing if the glideslope is inoperative or out of
service.
If Flying Full Approach Including Transition:
3. Airplane cleared to an initial approach fix
a. ACTIVATE THE APPROACH from the PROC page,
Or
ACTIVATE a DIRECT TO ( D ) the IAF
b. HSI CDI ...................................................................................... SELECT GPS Nav Source
c. Mode Control Panel .................................................................... PRESS NAV (GPS Mode)
NOTE
The airplane will navigate in GPS mode throughout the intermediate portion of the
approach procedure. When the airplane is inbound towards the final approach course,
the CDI will automatically switch from GPS navigation to LOC navigation.
d. Pathways ......................................................................................................... AS DESIRED
e. VERIFY ................................................................. Course pointer slews to the front course
4. Established inbound on Final Approach Course (FAF Active Waypoint)
a. VERIFY ................................................ Course Pointer is set to the final approach course
b. VERIFY ............................................................................. LOC is annunciated on the HSI
5. Airspeed ................................................. MAINTAIN 120 KIAS OR GREATER (Recommended)
6. At the FAF ..................................Use desired vertical mode to fly the approach’s vertical profile
Use Altitude Preselect to level off at intermediate altitudes and at the MDA