FAA Approved Airplane Flight Manual Supplement

190-00716-02 Rev. 1 Hawker Beechcraft King Air 300/300LW
FAA APPROVED Page 89 of 137
6. At the FAF ........................................................................ Descend via GP if LNAV+V approach
Use desired vertical mode to fly the approach’s vertical profile if LNAV approach
Use Altitude Preselect to level off at intermediate altitudes and at the MDA
NOTE
It is recommended to descend at 1000 ft/min or less. Descending at a higher rate or
reaching MDA too far before the Visual Descent Point (VDP) could cause TAWS or GPWS
alerts. If a TAWS or GPWS WARNING is issued, immediately follow the TAWS OR GPWS
WARNING procedure in the EMERGENCY PROCEDURES Section of this AFMS.
CAUTION
The autopilot/flight director will not capture ALT if descending in GP mode.
7. Level airplane in ALT mode at MDA .............................. PRESS NAV button 200 ft above MDA
If airplane is descending via GP, GP will extinguish and PIT mode will be active and
airplane will capture MDA.
8. AFTER LEVELING AT MDA ...................... SET Missed Approach Altitude In Altitude Preselect
VOR APPROACH
1. Load the approach into the Active Flight Plan .................................... VERIFY the G1000 tunes
the proper VOR frequency
2. Approach Minimums ...............................................SET ON TMR/REF page (if not already set)
If Flying Vectors-To-Final:
3. Airplane on Vectors-To-Final
a. Mode Control Panel .................................................. PRESS HDG to fly ATC radar vectors
b. PROC button on PFDs or GCU ......................SELECT ‘ACTIVATE VECTORS-TO-FINAL’
NOTE
SUSP may annunciate on the HSI when Vectors-To-Final is selected. The flight plan will
automatically un-suspend when the airplane intercepts and turns inbound on the final
approach course. When automatic flight plan waypoint sequencing resumes, SUSP will
extinguish.
c. HSI CDI ....................................................................... PRESS until VOR navigation source
To be used for the approach displays
d. Course Pointer ..................................................... Set to inbound course (if not already set)
e. Mode Control Panel ......................................................... PRESS APR, verify VAPP armed