FAA Approved Airplane Flight Manual Supplement

Hawker Beechcraft B300 and B300C King Air 190-00716-03 Rev. 1
Page 66 of 141 FAA APPROVED
USING ADC1 or ADC2
This message is displayed on both PFDs and indicates that both PFDs are displaying data from
the opposite side Air Data Computer. Normally the pilot’s side displays ADC 1 and the copilot’s
side displays ADC 2. Refer to GARMIN G1000 Cockpit Reference Guide for additional
information.
1. PILOT’S PFD SENSOR Softkey ............................................................................................ PRESS
2. PILOT’S PFD ADC1 Softkey .................................................................................................. PRESS
3. PFD Displays .............................. CONFIRM “BOTH ON ADC1” message displayed on both PFDs
4. COPILOT’S PFD SENSOR Softkey ....................................................................................... PRESS
5. COPILOT’S PFD ADC2 Softkey ............................................................................................ PRESS
6. PFD Displays ................................... CONFIRM “BOTH ON ADC 1” message clears on both PFDs
USING AHRS1 or AHRS2
This message is displayed on both PFDs and indicates that both PFDs are displaying data from
the opposite side Attitude Heading Reference System. Normally the pilot’s side displays AHRS 1
and the copilot’s side displays AHRS 2. Refer to GARMIN G1000 Cockpit Reference Guide for
additional information.
1. PILOT’S PFD SENSOR Softkey ............................................................................................ PRESS
2. PILOT’S PFD AHRS1 Softkey ............................................................................................... PRESS
3. PFD Displays ............................ CONFIRM “BOTH ON AHRS1” message displayed on both PFDs
4. COPILOT’S PFD SENSOR Softkey ....................................................................................... PRESS
5. COPILOT’S PFD AHRS2 Softkey .......................................................................................... PRESS
6. PFD Displays ................................. CONFIRM “BOTH ON AHRS 1” message clears on both PFDs
SYNTHETIC VISION
If SVS displays information inconsistent with G1000 primary flight instrumentation:
On the PFD:
1. PFD softkey ............................................................................................................................ PRESS
2. SYN VIS softkey ..................................................................................................................... PRESS
3. SYN TERR key ...................................................................................................................... PRESS
4. SVS is removed from both PFD displays .............................................................................. VERIFY
Use G1000 primary displays for navigation and aircraft control.
If G1000 operation in display backup mode is required:
Select display backup mode on the G1000 system. When display backup mode is selected, the
MFD will initially present a non-SVS (blue sky over solid brown ground) display. SVS will be
presented on the backup display within 20 seconds if it was enabled on the PFD when display backup
was selected.