Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 3-53
190-00915-01 Revision 9
3.35 GSM 85A Servo Mount Configuration
For software versions 0985.04 and later, the section 4.9.1 slip clutch torque check procedure requires the
correct type of GSM servo gearbox to be configured. It is not required to load this configuration if
GSM 86 servo gearboxes are installed for all servos (default configuration.)
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the
“SYSTEM UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Garmin Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air 200/B200 – GSM 85A Servo Mounts”. Press
ENT key on PFD1.
4. Verify “King Air 200/B200 – GSM 85A Servo Mounts” is displayed in the “Item” window.
5. Deselect any servos that have GSM 86 servo gearboxes installed by scrolling to the servo and
pressing ENT key on PFD1.
6. When all of the servos that have GSM 85A servo gearboxes are selected, press “LOAD” softkey.
7. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
8. Press ENT key on PFD1 to acknowledge upload complete.
9. Deactivate cursor.
10. Verify the servo mount configuration per section 3.37
.