Instruction Manual

Page 3-40 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 9 190-00915-01
3.26 TAWS-A Voice Callout Option Configuration
This section applies only to installations with the TAWS-A option. This step is necessary only if
TAWS-A voice callouts (400, 300, 200, 100) have been disabled and are now desired. TAWS-A voice
callouts are the default configuration. Follow the procedures outlined in this section to load the
necessary configuration files to enable TAWS-A voice callouts. Coordinate the TAWS-A Voice No
Callout Option configuration with Section 7.15 “TAWS Functional Check”.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the
“SYSTEM UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air - Airframe Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to select “King Air - TAWS-A Voice Callout Installation Option”.
Press ENT key on PFD1.
4. Verify the “King Air - TAWS-A Voice Callout Installation Option” is displayed in the “Item”
window. Press “LOAD” softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Select “ENT” key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.