Instruction Manual

Page 3-26 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 9 190-00915-01
3.12 GTS 820/850 Traffic System Configuration
Follow this procedure to enable the GTS 820/850 traffic system function for the G1000 system if
required.
NOTE
The G1000 can only be configured for TIS or
TAS/TCAS but not both.
Performing this procedure will automatically disable the TIS function.
Coordinate this configuration with Section 7.27 “GTS Traffic System
Functional Check”.
NOTE
Configuration of the GTS 820/850 TAS/TCAS I will require the GTS system
to be configured with the aircraft mode S address. Coordinate this
configuration with Section 3.48 “Aircraft Registration Number Entry.”
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “System
Upload” page on PFD1 using the small FMS knob.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Garmin Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air - GTS 8XX TAS/TCAS I”. Press ENT key
on PFD1.
4. Verify the “King Air - GTS 8XX TAS/TCAS1” is displayed in the “Item” window. Press
“LOAD”.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration and Software columns for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.