Manualshelf

Instruction Manual

ManualsBrandsGarmin ManualsFlight DecksGarmin MDL Rev 17, SA01535Wi_D
261262263264265266267268269270
Page 6-22 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 9 190-00915-01
5. Reinstall the cabin center floor panel.
6. If new unit is installed, register with Garmin Connext per Section 7.28.
7. Configure the GDL 59 per Section 3.33 and 3.17. Test the GDL 59 per Section 7.29.
6.34 GSR 56 Satellite Receiver
Removal:
1. Gain access by removing the cabin center floor panel at the main entry door.
2. Detach the two rack mount angles from the remote equipment shelf. Retain all mounting
hardware
.
3. Unlock the unit from the rack by loosening the ratcheting latch mechanism.
4. Remove the unit from the rack.
Reinstallation:
1. Visually inspect the connectors to ensure there are no bent or damaged pins. Repair any damage.
2. Insert the unit into the installation rack.
CAUTION:
Do not use excessive force when inserting the GDL 56 into the
rack. This may cause damage to occur to the connectors, unit,
and/or unit rack. If heavy resistance is felt during installation,
stop! Remove the GDL 56 and identify the source of resistance.
3. Lock the unit into the rack by using the ratcheting latch mechanism.
4. Reinstall the cabin center floor panel.
5. If new unit is installed, register with Garmin Connext per Section 7.28.
6. No configuration is required for the GSR 56. Test the GSR 56 according to Section 7.30.
6.35 GTS Traffic Processor
Removal:
1. Gain access to the left forward avionics compartment in the nose of the aircraft.
2. Disconnect the eight coaxial cable connectors.
3. Disconnect the three electrical connectors.
4. Unlock the unit from the rack by loosening the ratcheting latch mechanism.
5. Remove the unit from the rack.
Reinstallation:
1. Visually inspect the connectors to ensure there are no bent or damaged pins. Repair any damage.
2. Insert the unit into the installation rack.
3. Lock the unit into the rack by using the ratcheting latch mechanism.
4. Connect the eight coaxial cable connectors. Note the color coded bands which match the mating
connectors.
5. Connect the three electrical connectors.