Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 4-11
190-00915-01 Revision 9
4.3.1 Discontinued Maintenance
Table 4-2 shows a list of inspections and tests that are listed in the King Air 200 Series Maintenance
Manual, but may be no longer required post incorporation of this STC. It is the responsibility of the
installer to ensure that there are no post factory installations that would require these checks to remain.
Table 4-2, Discontinued Maintenance Intervals
Item Description/Procedure Manual Interval
AC Inverter Operational Check Phase Inspections Phases 1, 2, 3 & 4
Dual Bus Feeder
Diode
Inspection of Dual Bus Feeder Diodes 24-50-00
Phase 3
(superseded by 4.17.2)
IMPORTANT!
For installed equipment not listed in this maintenance manual, use the inspection
procedures set forth in Chapter 05 of the King Air 200 Series Maintenance Manual,
or other appropriate maintenance manual, as the requirements set forth by those
manuals are still applicable. The requirements set forth by this document take
precedence over those set forth by the King Air 200 Series Maintenance Manual, or
other appropriate maintenance manual, in cases where the requirements conflict.