Instruction Manual

Page 4-4 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 9 190-00915-01
4.2.3 Special Tools
The following tools are needed to perform maintenance tasks on G1000 equipment and/or installation:
• GSM 85A Servo Gearbox Slip Clutch Adjustment Tool – Garmin P/N T10-00110-01
• WX-PA portable analyzer kit, Part Number 78-8060-5791-1 (If Stormscope is installed)
• Gauging Equipment Tool SPF-4 (A1M-BCH-GE) *
• Lift Computer Breakout Box – P/N SK100360 or equivalent
(if ESP with AOA option is installed)
• Lift Transducer Force Applicator Kit – Safe Flight P/N 1952-1-3-5
(if ESP with AOAoption is installed)
• For software loader code 0985.07 – GRA 5500 Sensor and Main Software (If GRA 5500 is
installed) – Garmin P/N per GA Drawing 005-00421-03 obtained from www.garmin.com web-
site from instructions in Section 3.29.1
• For software loader code 0985.07 – GRA 5500 Retrofit Tool (If GRA 5500 is installed) – Garmin
P/N 006-A0451-00 obtained from www.garmin.com web-site from instructions in Section 3.29.1
* The gauging equipment tool is used for the static port inspection for RVSM
compliant aircraft only. This tool is available from Hawker Beechcraft. Any
alternate tool authorized in the King Air 200 Series Maintenance Manual for RVSM
static port measurements may be substituted for this tool. Refer to Chapter 34-10-00
of the King Air 200 Series Maintenance Manual for more details.