Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 4-3

190-00915-01 Revision 9

4.2.2 Required Tools

The following tools are needed to perform maintenance tasks on G1000 equipment:

• Calibrated Milli-ohm meter, OR

• Agilent 34410A Ammeter or equivalent

• Fluke 187 Voltmeter or equivalent

• Variable DC Power Supply capable of providing 1 amp current

• #2 Non-Magnetic Phillips Screwdriver

• 3/32” Hex tool

• Calibrated digital level (Required for AHRS ‘Procedure A’ Calibration)

• Calibrated VHF NAV/COM/ILS ramp tester or equivalent

• Calibrated transponder ramp tester or equivalent

• Calibrated pitot/static ramp tester

• Outdoor line-of-site to GPS satellite signals or GPS indoor repeater

• Headset/microphone

• Ground Power Unit (Capable of supplying 28 Vdc)

• Calibrated Flight Control Cable Tension Meter or equivalent

• 2 Amp, 24 V, DC Power Supply

• Calibrated torque wrench capable of measuring 0 – 70 in/lbs

• Standard sockets & wrenches (3/8”, 9/16”, and 13/16”)

• Calibrated digital thermometer suitable for measuring ambient temperature

• Laptop with RS232 emulation software

• M22885/108T8234 extraction tool

• An 0.060” 6-Spline wrench