Instruction Manual

Page 3-66 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 9 190-00915-01
3.48.2 System Software Version 0985.07 and Subsequent
1. With PFD1 in configuration mode, select the AIRCRAFT CONFIGURATION page on PFD1.
2. Select the ‘AIRCRAFT REGISTRATION’ field and enter the aircraft’s tail number.
3. Select the ‘ICAO ADDRESS’ and enter the aircraft’s 24 bit ICAO address.
4. If applicable, select the ‘IATA AIRLINE DESIGNATOR’ field and enter the airline’s 2 digit
airline designator code.
5. Select the ‘VFR CODE’ field and enter the desired code that will become active when the VFR
key on the GDU is pressed.
6. Press the ‘SET GTX1’ softkey and acknowledge the PFD1 prompt by pressing the ‘ENT’ key.
7. Press the ‘SET GTX2’ softkey and acknowledge the PFD1 prompt by pressing the ‘ENT’ key.
8. Press the ‘SET GTS’ softkey and acknowledge the PFD1 prompt by pressing the ‘ENT’ key.
9. After completing transponder configuration, deactivate the cursor.
3.49 V1 / V2 Airspeed Options
This option increases the selectable range of the V1 airspeed bug and adds the V2 airspeed bug for
aircraft having these parameters defined.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “System
Upload” page using the PFD1 small FMS knob.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Airframe Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “V1 Airspeed Options”. Press ENT key on PFD1.
4. Verify “V1 Airspeed Options” is displayed in the “Item” window. Press “LOAD” softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration column for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.