Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-00929-04 Rev. A
Appendix
144
Flight
Instruments
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
FeaturesAnnun/AlertsAppendixIndex
Level 1 Level 2
Description
SHW
CHRT
When available, displays optional airport and
terminal procedure charts
CHKLIST
When available, displays optional checklists
LOADING UPDATED DATABASES
Database information is obtained from third party sources. Inaccuracies in the data
may be discovered from time to time. Garmin communicates this information by issu-
ing a Database Alert. These notifications are available on http://fly.garmin.com.
Garmin requests the flight crew report any observed discrepancies related to
database information. These discrepancies could come in the form of an incorrect
procedure; incorrectly identified terrain, obstacles and fixes; or any other displayed
item used for navigation or communication in the air or on the ground. Go to http://
fly.garmin.com and select “Aviation Data Error Report”.
CAUTION: Never disconnect power to the system when loading a database.
Power interruption during the database loading process could result in
maintenance being required to reboot the system.
NOTE: When loading database updates, the ‘DB Mismatch’ message will
be displayed until database synchronization is complete, followed by turning
system power off, then on. Synchronization can be monitored on the AUX-
SYSTEM STATUS Page.
In some cases it may be necessary to obtain an unlock code from Garmin in order
to make the database product functional. It may also be necessary to have the system
configured by a Garmin authorized service facility in order to use some database
features.
If an error occurs during synchronization, an error message will be displayed,
followed by the affected display in the Sync Status section of the Database Window. If
synchronization completes on one display, but an error occurs on another, the error
message will be displayed with the affected displays listed after it. When an error
message is displayed, the problem must be corrected before synchronization can be
completed. A power cycle is required to restart synchronization when ‘Card Full’ or
‘Err’ is shown.