Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Beechcraft 200/B200 Series
190-00929-04 Rev. A
30
Flight Planning
Flight
Instruments
Nav/Com/
XPDR/AudioAFCSGPS Nav
Flight
PlanningProcedures
Hazard
Avoidance
Additional
FeaturesAnnun/AlertsAppendixIndex
3) Use the small FMS Knob to select ‘TIME’ or ‘DIST’ length mode, and press
the ENT Key.
4) Use the FMS Knobs to edit the length, and press the ENT Key.
5) Use the small FMS Knob to select ‘RIGHT’ or ‘LEFT’ turn direction, and
press the ENT Key.
6) Use the FMS Knobs to edit the Expect Further Clearance Time (EFC TIME),
and press the ENT Key.
7) Press the ENT Key while ‘ACTIVATE?’ is highlighted to immediately activate
the hold.
Creating a User-Defined Hold at a Direct-To Waypoint:
1) Press a Direct-to Key on the Control Unit and set up the Direct To
waypoint as desired, but select ‘HOLD?’ instead of ‘ACTIVATE?’ when
finished.
2) Use the FMS Knobs to edit the entry course, and press the ENT Key.
5) Use the small FMS Knob to select ‘INBOUND’ or ‘OUTBOUND’ course
direction, and press the ENT Key.
6) Use the small FMS Knob to select ‘TIME’ or ‘DIST’ length mode, and press
the ENT Key.
7) Use the FMS Knobs to edit the length, and press the ENT Key.
8) Use the small FMS Knob to select ‘RIGHT’ or ‘LEFT’ turn direction, and
press the ENT Key.
9) Use the FMS Knobs to edit the Expect Further Clearance Time (EFC TIME),
and press the ENT Key.
10) Press the ENT Key while ‘ACTIVATE?’ is highlighted to activate the Direct To
with the user-defined hold defined at the Direct To waypoint.
Exiting a user-defined hold inserted into the active flight plan:
Press the SUSP Softkey. The system will provide guidance to follow the
holding pattern to the inbound course and resume automatic waypoint
sequencing.