Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 4-7
190-00915-01 Revision 8
Item Description/Procedure
Manual
Section No.
Interval
GSA 80 Servos (all)
Removal & Replacement.
Refer to Master Drawing List, listed in Table
1-2, for installation drawings.
6.11 On Condition
GSM 85A /86 Servo
Gear Box (all)
Removal & Replacement.
Refer to the servo install drawings listed in
Master Drawing List, listed in Table 1-2.
6.12 On Condition
GSM 86 Servo Gear
Box Slip Clutch
Torque Check *
For installations with the GSM 86 servo
gearbox, verify that the pitch, roll, yaw
and pitch trim GSM 86 slip clutch torque
values are within acceptable limits
4.9
Special
3,000 hours max
GSM 85A Servo
Gear Box Slip
Clutch Torque
Check *
For installations with the GSM 85A servo
gearbox, verify that the pitch, roll, yaw
and pitch trim GSM 85A slip clutch
torque values are within acceptable limits
4.9 420 hours max
WOW and Low
Speed Awareness
Band Check*
Verify the integrity of the wiring interface
between the landing gear safety switch
assembly and the No. 1 and No. 2 GIA
inputs and the air ground status logic.
7.22 220 hours max
Exterior skin
inspection around
antennas*
Inspect the exterior skin around
antennas for cracks and loose and
missing fasteners per Super King Air 200
Series Maintenance Manual,
section 53-10-00, chart 201.
NA
Special
10,000 cycles
(initial)
1,000 cycles
(repeat)
G1000 Accessories
Configuration Module
Replacement (Qty 7)
Removal & Replacement.
6.16
On Condition
GEA 71 Backshell
Thermocouple (Qty 2)
Removal & Replacement. 6.17
GTP 59 OAT Probe
(Qty 2)
Removal & Replacement.
6.7
PFD, MFD, and GIA
Cooling Fans (Qty 5)
Removal & Replacement
Refer to Master Drawing List, listed in Table
1-2, for installation drawings.
N/A
G1000 Lightning Protection
Electrical Bonding
Test
Perform the Phase 3 electrical bonding
resistance check of G1000 equipment
4.5.3 Phase 3
Perform the Phase 4 electrical bonding
resistance check of G1000 equipment
4.5.4 Phase 4
Lightning Strike to
GTP 59 OAT Probe
or Antenna
Actual or Suspected
Inspect the antenna/probe and surrounding
installation per Table 4-9.
4.4 On Condition
* Denotes Airworthiness Limitation Maintenance Requirement (See Section 4.1)