Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 4-3
190-00915-01 Revision 8
4.2.2 Required Tools
The following tools are needed to perform maintenance tasks on G1000 equipment:
• Calibrated Milli-ohm meter, OR
• Agilent 34410A Ammeter or equivalent
• Fluke 187 Voltmeter or equivalent
• Variable DC Power Supply capable of providing 1 amp current
• #2 Non-Magnetic Phillips Screwdriver
• 3/32” Hex tool
• Calibrated digital level (Required for AHRS ‘Procedure A’ Calibration)
• Calibrated VHF NAV/COM/ILS ramp tester or equivalent
• Calibrated transponder ramp tester or equivalent
• Calibrated pitot/static ramp tester
• Outdoor line-of-site to GPS satellite signals or GPS indoor repeater
• Headset/microphone
• Ground Power Unit (Capable of supplying 28 Vdc)
• Calibrated Flight Control Cable Tension Meter or equivalent
• GSM 85A Servo Gearbox Slip Clutch Adjustment Tool – Garmin P/N T10-00110-01 and a
2 Amp, 24 V, DC Power Supply
• Calibrated torque wrench capable of measuring 0 – 70 in/lbs
• Standard sockets & wrenches (3/8”, 9/16”, and 13/16”)
• Calibrated digital thermometer suitable for measuring ambient temperature
• Laptop with RS232 emulation software
• M22885/108T8234 extraction tool
• An 0.060” 6-Spline wrench
• WX-PA portable analyzer kit (If Stormscope is installed)
• Lift Computer Breakout Box – P/N SK100360 or equivalent
(if ESP with AOA option is installed)
• Lift Transducer Force Applicator Kit – Safe Flight P/N 1952-1-3-5
(if ESP with AOAoption is installed)
• Gauging Equipment Tool SPF-4 (A1M-BCH-GE) *
* The gauging equipment tool is used for the static port inspection for RVSM
compliant aircraft only. This tool is available from Hawker Beechcraft. Any
alternate tool authorized in the King Air 200 Series Maintenance Manual for RVSM
static port measurements may be substituted for this tool. Refer to Chapter 34-10-00
of the King Air 200 Series Maintenance Manual for more details.