Instruction Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 3-39
190-00915-01 Revision 8
3.26 GSM 86 Servo Mount Configuration
For software versions 0985.04 and later, the section 4.9.1 slip clutch torque check procedure requires the
correct type of GSM servo gearbox to be configured. If a GSM 85A servo gearbox is replaced by a GSM
86 servo gearbox, follow the steps below to load the configuration. It is not necessary to load this
configuration if GSM 86 servo gearboxes are already installed for all servos (default configuration.)
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “SYSTEM
UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display drop down menu. Highlight King Air - Options
and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air 200/B200 – GSM 86 Servo Mounts”. Press ENT key
on PFD1.
4. Verify “King Air 200/B200 – GSM 86 Servo Mounts” is displayed in the “Item” window.
5. Deselect any servos that have GSM 85A servo gearboxes installed by scrolling to the servo and pressing
ENT key on PFD1.
6. When all of the servos that have GSM 86 servo gearboxes are selected, press “LOAD”.
Figure 3-37, GSM 86 Servo Mount Configuration
7. Monitor load progress. Verify software load completes without errors as indicated by the following:
• Green “PASS” in Configuration column for PITCH SERVO, PITCH TRIM SERVO, ROLL SERVO
and/or YAW SERVO (as selected).
• “Upload Complete………….COMPLETE” in the summary box.
8. Press ENT key on PFD1 to acknowledge upload complete.
9. Deactivate cursor.
10.
Verify the servo mount configuration per section 3.27.