Instruction Manual

Page 3-34 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 8 190-00915-01
3.20 ESP Support (with AOA) Option Configuration
This section applies only to installations with the ESP option with AOA modes. A new Safe Flight lift
computer is used for this configuration. The procedures outlined in this section must be followed to load
the necessary configuration files required to enable ESP messages and functions. An Enhanced AFCS
unlock card is also required for this option (see Section 3.34.)
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “SYSTEM
UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display drop down menu. Highlight King Air - Options
and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “200/B200 ESP Support (with AoA)”. For software version
0985.03, the option is labeled “King Air 200/B200 Series - ESP Support”. Press ENT key on PFD1.
4. Verify “200/B200 ESP Support (with AoA)” or “King Air 200/B200 Series - ESP Support” is displayed
in the “Item” window. Press “LOAD”.
Figure 3-32, ESP Support Configuration
5. Monitor load progress. Verify software load completes without errors as indicated by the following:
• Green “PASS” in Configuration column for AIRFRAME, MANIFEST, ALERTS, GIA1, GIA2 and
GEA 1.
• Green “PASS” in Software column for GIA CERT, PITCH CERT, ROLL CERT, YAW CERT and
PITCH TRIM CERT.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.