Instruction Manual

Page 3-22 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 8 190-00915-01
3.9.3 Software Check
Anytime software and configuration loading procedures are accomplished during maintenance, conduct a
final software review of the system.
1. Start the PFD in Configuration Mode as described in Section 3.7.
2. Go to the System Status page using the FMS knob. Activate the cursor and toggle to the LRU
window.
Figure 3-20, System Status
3. The PFD System Status page shows a list of LRUs in the LRU window. Activate the cursor and
highlight the LRU window. Use the FMS knob to scroll through the list in the window and verify
that the software part number and version displayed in the DATA window matches the
information in General Arrangement drawing listed in Table 1-2. Record the results on the next
page.
IMPORTANT!
It is essential that the software versions be checked and matched against the listed
versions in the General Arrangement drawing listed in Table 1-2. Software
Configuration is a critical part of the G1000 operation and must be verified before
returning an aircraft to service.
If any software version and/or part number does not match those specified by the
General Arrangement drawing, or if the software is not successfully loaded, DO
NOT continue. Troubleshoot and resolve the issue before continuing.