Instruction Manual

Page 7-60 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 8 190-00915-01
24. On the GCU, rotate the inner FMS knob to activate the AUX – SYSTEM SETUP page.
25. On the MFD AUX – SYSTEM SETUP page press the SETUP 2 softkey.
26. Verify that on the MFD SETUP 2 page there is a window for Stability & Protection and the status
is “ENABLED”.
27. Verify on PFD 1 and PFD 2 that there are no “ESP FAIL”, “ESP OFF”, or “ESP DEGRADE”
alert messages.
28. On the GMC 710, couple the Flight Director to the right side by pressing the XFR button. The
arrow that is illuminated indicates which side is coupled. No flight director modes should be
active at this time.
NOTE
On power up the coupled side will default to the left side. Each time power is
reapplied couple back to the right side and continue test steps.
29. Repeat step 1 thru 27 while coupled to right side.
30. Remove power to the aircraft and avionics systems by placing the aircraft AVIONICS MASTER
PWR and BATT switches to OFF.
31. Wait ~ 1 minute before re-applying power for further testing as required.