Instruction Manual

Page 1-2 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 8 190-00915-01
IMPORTANT!
If the technician is unsure of an aircraft’s STC configuration, perform the
following:
After acknowledgement of the splash screen, use the FMS knob on the GCU 477 controller to go to the
AUX – SYSTEM STATUS page on the MFD. In the AIRFRAME section (upper right corner,) the
display shows the current G1000 airframe configuration and system software version number. The
airframe configuration is shown in the AIRFRAME field and the system software version number is
shown in the following format: ‘SYS SOFTWARE VERSION XXXX.XX’. It correlates to the software
image used to load the software to the system:
EXAMPLE:
System Software Version
‘0985.01’ = Software Image P/N 006-B0985-01
Restart the MFD in configuration mode (see section 3.7) and use the FMS knob on the GCU 477
controller to go to the GDU-AIRFRAME CONFIGURATION page. In the AIRFRAME section (upper
right corner), verify the correct configuration for SERIES, ENGINE and PROP.
EXAMPLE:
For a configuration that loaded “King Air B200 PT6A-42” with a “McCauley 3-BLADE” propeller, the
AIRFRAME section should display:
SERIES: B200
ENGINE: PT6A-42
PROP: MCCAULEY 3