System Maintenance Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 3-49
190-00915-01 Revision 7
3.37 Aircraft Registration Number Entry
1. If not applied, apply power to the G1000 system.
2. With PFD1 in configuration mode, select the GTX page group, then select the TRANSPONDER
CONFIGURATION page.
3. The ‘ADDRESS TYPE’ default is ‘US TAIL’. To enter a non-US Mode-S registration number
set the ‘ADDRESS TYPE’ field to ‘HEX ID’.
4. Activate the cursor and highlight the ‘MODE S ADDRESS’ field. Use the small/large FMS
knobs to enter the US aircraft registration number or other Mode-S registration number.
Figure 3-47, Aircraft Registration
5. For US registered aircraft, the ‘FLIGHT ID TYPE’ field should be set to ‘SAME AS TAIL’.
For other aircraft, the ‘FLIGHT ID TYPE’ field should be set to ‘CONFIG ENTRY’ or
‘PFD ENTRY’.
NOTE
The CONFIG ENTRY setting requires the Aircraft Registration/ID number to be entered
once in the ‘FLIGHT ID’ field. The PFD ENTRY setting allows the pilot to enter the
Aircraft Registration/ID number from the PFD, via the ‘TMR/REF’ softkey.
6. After each configuration setting change, press the ENT key to configure the transponders.
7. Press the ENT key on PFD1 to acknowledge prompt.
8. After completing transponder configuration, deactivate the cursor.