System Maintenance Manual

G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air Page 3-35
190-00915-01 Revision 7
3.21 ESP Support (no AOA) Option Configuration
This section applies only to installations with the ESP option without AOA modes (available in software
version 0985.04 and later.) The original Safe Flight lift computer is used for this configuration. The
procedures outlined in this section must be followed to load the necessary configuration files required to
enable ESP messages and functions. An Enhanced AFCS unlock card is also required for this option (see
Section 3.34.)
NOTE
If the ESP Support (with AOA) Option Configuration was previously loaded (see Section
3.20), the baseline configuration must be reloaded before proceeding with this procedure.
Reload the baseline configuration for the specific airframe and all applicable options as
described in Section 3.9. Reloading the baseline configuration disables all previously
enabled options.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “SYSTEM
UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display drop down menu. Highlight King Air - Options
and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “ESP Support (no AOA)”. Press ENT key on PFD1.
4. Verify “ESP Support (no AOA)” is displayed in the “Item” window. Press “LOAD”.
Figure 3-33, ESP Support Configuration
5. Monitor load progress. Verify software load completes without errors as indicated by the following:
• Green “PASS” in Configuration column for AIRFRAME, ALERTS, GIA1 and GIA2.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.