System Maintenance Manual

Page 7-58 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 7 190-00915-01
5. On the GMC 710 couple the Flight Director to the left side by pressing the XFR button. The
arrow that is illuminated indicates which side is coupled. No flight director modes should be
active at this time.
6. On the GCU, rotate the inner FMS knob to activate the AUX – SYSTEM SETUP page on the
MFD.
7. On the MFD AUX – SYSTEM SETUP page press the SETUP 2 softkey.
8. Verify that on the MFD SETUP 2 page there is a window for Stability & Protection and the status
is “ENABLED”.
9. Verify on PFD 1 and PFD 2 that there are no “ESP FAIL”, “ESP OFF”, or “ESP DEGRADE”
alert messages.
10. Cover both GPS1 and GPS2 antennas.
11. Verify on PFD 1 and PFD 2 the ESP Roll Indices are displayed at 45° on the roll indicator on the
Attitude Display.
12. For installations with AOA mode, verify on PFD 1 and PFD 2 that there is an “ESP DEGRADE”
alert message.
13. On the GCU, press the inner FMS knob to activate the cursor then rotate the outer FMS knob to
select the Stability & Protection window on the MFD.
14. Rotate the inner FMS knob to change the status to “DISABLED”.
15. Verify that on the MFD SETUP 2 page Stability & Protection window that the status is
“DISABLED”.
16. Verify on PFD 1 and PFD 2 the ESP Roll Indices are not displayed at 45° on the roll indicator on
the Attitude Display.