Pilot's Guide

Garmin G1000 Pilot’s Guide for the Beechcraft C90A/GT/GTi
190-00663-03 Rev. A560
APPENDIX A
GMC 710 MESSAGE ADVISORIES
Message Comments
GMC CNFG – GMC Config error.
Config service req’d.
Error in the configuration of the GMC 710.
GMC FAIL – GMC is inoperative. A failure has been detected in the GMC 710. The GMC 710 is unavailable.
MANIFEST – GMC software
mismatch, communication halted.
The GMC 710 has incorrect software installed. The G1000 system should be serviced.
GMC KEYSTK – GMC [keyname] Key
is stuck
A key is stuck on the GMC 710 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
GWX 70 MESSAGE ADVISORIES
Message Comments
GWX CONFIG – GWX config error.
Config service req’d.
GWX 70 configuration settings do not match those of the GDU configuration. The
G1000 system should be serviced.
GWX FAIL – GWX is inoperative. The GDU is not recieving status packet from the GWX 70 or the GWX 70 is reporting
a fault. The GWX 70 radar system should be serviced.
GWX SERVICE – Needs service.
Return unit for repair.
A failure has been detected in the GWX 70. The GWX 70 may still be usable.
WX ALERT – Possible severe weather
ahead.
The GWX 70 indicates severe weather within ±10 degrees of the aircraft heading at a
range of 80 to 320 nm.
MANIFEST – GWX software
mismatch, communication halted.
The GWX 70 has incorrect software installed. The G1000 system should be serviced.
MISCELLANEOUS MESSAGE ADVISORIES
Message Comments
FPL WPT LOCK – Flight plan waypoint
is locked.
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an navigation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
Or - update the waypoint name/identifier to reflect the new information.
FPL WPT MOVE – Flight plan
waypoint moved.
The system has detected that a waypoint coordinate has changed due to a new
navigation database update. Verify that stored flight plans contain correct waypoint
locations.
TIMER EXPIRD – Timer has expired. The system notifies the pilot that the timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures.
This occurs when a stored flight plan contains a procedure that is no longer consistent
with the navigation database. This alert is issued only after an navigation database
update. Verify that the user-modified procedures in stored flight plans are correct and
up to date.
DB CHANGE – Database changed.
Verify stored airways.
This occurs when a stored flight plan contains an airway that is no longer consistent
with the navigation database. This alert is issued only after an navigation database
update. Verify use of airways in stored flight plans and reload airways as needed.