Pilot's Guide

190-00663-03 Rev. A
Garmin G1000 Pilot’s Guide for the Beechcraft C90A/GT/GTi
365
HAZARD AVOIDANCE
SELECTING THE STORMSCOPE PAGE
Stormscope lightning data can be displayed at the ranges of 25 nm, 50 nm, 100 nm, and 200 nm.
Adjusting the Stormscope Map Range:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Stormscope Page.
3) To change the map range, turn the Joystick clockwise to zoom out or counter-clockwise to zoom in.
Figure 6-78 Stormscope Page
Changing between ‘cell’ and ‘strike’ mode:
1) Select the Stormscope Page.
2) Select the MODE Softkey. The CELL and STRIKE softkeys are displayed.
3) Select the CELL Softkey to display ‘CELL’ data or select the STRIKE Softkey to display ‘STRIKE’ data. ‘CELL’ or
‘STRIKE’ is displayed in the mode box in the upper left corner of the Stormscope Page.
4) Press the BACK Softkey to return to the Stormscope Page.
Or:
1) Select the Stormscope Page.
2) Press the MENU Key.
3) Turn the small FMS Knob to choose between ‘CELL’ and ‘STRIKE’ options.
4) When an item is selected, press the ENT Key.
If heading input is lost, strikes and/or cells must be cleared manually after the execution of each turn. This
is to ensure that the strike and/or cell positions are depicted accurately in relation to the nose of the aircraft.