System Maintenance Manual

Page 4-4 G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air
Revision G 190-00682-01
4.2.2 Required Tools
The following tools are needed to perform maintenance tasks on G1000 equipment:
• Calibrated Milli-ohm meter, OR
 Agilent 34410A Ammeter or equivalent
 Fluke 187 Voltmeter or equivalent
 Power Supply capable of providing 1 amp current
• #2 Non-Magnetic Phillips Screwdriver
• 3/32” Hex tool
• Calibrated digital level (Required for AHRS ‘Procedure A’ Calibration)
• Calibrated VHF NAV/COM/ILS ramp tester or equivalent
• Calibrated transponder ramp tester or equivalent
• Calibrated pitot/static ramp tester
• Outdoor line-of-site to GPS satellite signals or GPS indoor repeater
• Headset/microphone
• Ground Power Unit (Capable of supplying 28 Vdc)
• Calibrated Flight Control Cable Tension Meter or equivalent
• Servo Mount Slip Clutch Adjustment Tool – Garmin P/N T10-00110-01 and a 2 Amp, 24 V, DC
Power Supply
• Calibrated torque wrench capable of measuring 0 – 70 in/lbs
• Standard sockets & wrenches (3/8”, 9/16”, and 13/16”)
• Calibrated digital thermometer suitable for measuring ambient temperature
• Laptop with RS232 emulation software
• M22885/108T8234 extraction tool
• An 0.060” 6-Spline wrench
• WX-PA portable analyzer kit (If Stormscope is installed)