System Maintenance Manual

G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air Page 3-53
190-00682-01 Revision G
8. Apply power to the MFD and repeat steps 5 and 6.
9. Remove the loader card from the MFD and insert it into the upper slot of PFD1.
10. Apply power to PFD1 and repeat steps 5 and 6.
11. Cycle power to the MFD and splash screen will be present.
NOTE
Any time software and/or configuration is loaded to the system, the splash
screens may need to be reloaded to all three display units.
3.12 Clearing Default User Settings
1. Remove power from PFD1, PFD2 and MFD by pulling the PFD1 PRI, PFD1 SEC, PFD2 and
MFD circuit breakers.
2. While holding the CLR button on PFD1, reset PFD1 PRI and PFD1 SEC circuit breakers.
3. While holding the CLR button on PFD 2, reset the PFD2 circuit breaker.
4. While holding the second key from the right side of the MFD (beginning on the right side of the
MFD, count 2 keys to the left), reset the MFD circuit breaker.
5. When prompted to clear user settings, select the YES softkey on each unit.