System Maintenance Manual

G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air Page 3-35
190-00682-01 Revision G
3.9.4.2.3 Loading Airspeed Indication Marking Configuration
Aircraft serial numbers LJ-1063 through LJ-1137 and LJ-1146 must load the airspeed configuration file
King Air C90 – Airspeed LJ 1063 – 1137,1146 .
Aircraft serial numbers LJ-1138-1299 except 1146, 1288, and 1295 must load the airspeed configuration
file King Air C90 – Airspeed LJ 1138-1299 Except 1146, 1288, and 1295.
All other aircraft not included in this serial number range are not required to load this additional airspeed
indication marking configuration.
Follow this procedure to enable the airspeed marking configuration.
1. While in configuration mode and loader card inserted in the top card slot of PFD1, select the “System
Upload” page using the PFD1 small FMS knob.
2. Activate cursor in AIRFRAME window and rotate PFD1 FMS inner knob to display drop down
menu. Highlight “C90-Weight and Airspeed” and press ENT key on PFD1.
3. Verify cursor drops down to the file box. Rotate the inner FMS knob to view the list of available C90
configurations.
4. Use the FMS inner knob to select the correct airspeed indicator marking configuration file. Press
ENT.
5. Verify the correct configuration file is displayed in the “FILE” window (for example “King Air C90 –
Airspeed LJ 1063 – 1137,1146”) then press “LOAD”.
6. Monitor load progress. Verify software load completes without errors as indicated by the following:
a. Green “PASS” in Configuration column.
b. “Upload Complete………….COMPLETE” in the summary box.
7. Select PFD1 ENT key to acknowledge upload complete.
3.9.4.2.4 Airspeed Configuration Load Confirmation
1. Accomplish Airspeed Test in Section 7.6.1 to verify the correct airspeed configuration, as loaded in
Section 3.9.4.2.3.
Aircraft LJ-1063 through LJ-1137, and LJ-1146: Vyse = 107 kts, Vmca = 90 kts , Vs1 = 89 kts
Aircraft LJ-1138 through 1299 except 1146, 1288, and 1295: Vyse = 108 kts, Vmca = 90 kts,
Vs1 = 88 kts