System Maintenance Manual

Page 3-32 G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air
Revision G 190-00682-01
IMPORTANT!
If the aircraft being modified has incorporated any modifications beyond factory
configuration or the STCs listed above that effect engine or airspeed limitation, your
configuration may not be supported at this time. It is the responsibility of the
installer to ensure compatibility with existing modifications.
3.9.4.1.1 Loading Airframe Configuration
1. While in configuration mode and loader card inserted in the top card slot of PFD 1, select the
“System Upload” page using the small FMS knob.
2. Activate cursor and rotate small knob to display drop down menu. Highlight “C90-
Configurations” or “C90-Configurations 2” and press ENT key on PFD 1.
3. Verify cursor drops down to the file box. Rotate the small FMS knob to view the list of available
C90 configurations.
4. Use the FMS small knob to select the correct configuration file as determined above. Press ENT.
5. Verify the correct configuration file is displayed in the “File” window (for example “King Air
C90A – Config 7”) then press “LOAD”.
6. Monitor load progress. Verify software load completes without errors as indicated by the
following:
a. Green “PASS” in Configuration column.
a. “Upload Complete………….COMPLETE” in the summary box.
7. Select ENT key on PFD 1 to acknowledge upload complete.
3.9.4.1.2 Airframe Configuration Load Confirmation
1. Use the large FMS knob to select the GDU page group and the small FMS knob to select
“AIRFRAME CONFIGURATION” page.
2. Verify the correct airframe configuration, as loaded above, is displayed in the
“IDENTIFICATION” window.