Technical Reference Guide

Technical Reference for Garmin NMEA 2000 Products 35
NMEA 2000 Checklist
Location TEMPSOURCE Value Location TEMPSOURCE Value
Water 0 Live well 5
Air outside 1 Bait well 6
Air inside 2 Refrigeration 7
Engine room 3 Heating system 8
Main cabin 4 Freezer 13
To congure the temperature offset if the menu option is not displayed:
If the temperature data displayed on the gauge connected to the GST 10 adapter is not the same as temperature data displayed on other devices,
you can congure the temperature offset to increase or decrease the displayed temperature by a specic amount.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
• For most Garmin chartplotters, select Review > Generic Cong.
• For other Garmin marine devices, select Cong >Generic Conguration.
3. Enter the following command: “TEMPOFFSET=”
4. After the command, enter a positive or negative decimal number, followed by Done.
For example, TEMPOFFSET=-2.5Done indicates that the temperature readings displayed on the gauge connected to the GST 10 adapter
will be decreased by 2.5 degrees Celsius.
To congure the sensor number if the menu option is not displayed:
If multiple GST 10 adapters are assigned to the same NMEA 2000 temperature source, each adapter is assigned a unique sensor number
automatically. If the “Invalid NMEA 2000 temperature conguration” error message appears, you must assign a unique sensor number to each
adapter.
For example, if two adapters are assigned the NMEA 2000 temperature source value of Live Well and the error message appears, you must
assign each adapter a unique number.
1. From the NMEA 2000 Devices list, select one of the GST 10 devices assigned to the same temperature source.
2. Select an option:
• For most Garmin chartplotters, select Review > Generic Cong.
• For other Garmin marine devices, select Cong >Generic Conguration.
3. Enter the following command: “INSTANCE=”
4. After the command, enter a positive decimal number, followed by Done.
5. Repeat steps 1–4 for each GST 10 device assigned to the same temperature source.
For example, if two GST 10 adapters are assigned the value of Live Well, assigning INSTANCE=1 to the rst adapter and assigning
INSTANCE=2 to the second adapter prevents the error message.
Restoring Factory Default Settings
You will lose all custom conguration settings when you restore factory default settings.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
• For most Garmin chartplotters, select Review > Factory Defaults.
• For other Garmin marine devices, select Cong > Factory Defaults.
3. Select Yes.