Pilot's Guide

2-3190-01150-02 Rev. F
Garmin G500H Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
NOTE: If a soft key is pressed and held for longer than 1 second, it is
ignored.
CDI
The CDI soft key toggles between the selection of GPS or VOR/LOC as the
active navigation source. The GDU CDI soft key will change the source in
the connected navigator and making a source change in the navigator will be
reflected in the GDU 620.
1-2
The 1-2 soft key toggles between the available receivers for selected navigation
source (i.e. GPS1 and GPS2 or VOR/LOC1 and VOR/LOC2). This soft key
will only be present if the system is configured for a second GPS or VOR/
LOC.
ATT SYNC
Pressing the ATT SYNC soft key will synchronize the aircraft symbol on the
PFD to the horizon line during level flight. The ATT SYNC soft key will not
be available for selection until the aircraft is near a level pitch attitude (within
±8º).
PFD
Pressing the PFD soft key displays the BRG1, BRG2, and BACK soft keys.
The BRG2 soft key will only be present if the system is configured for a
second GPS or VOR/LOC receiver.
BRG1
The BRG1 soft key cycles through the available bearing 1 indicator modes
(NAV1, GPS1, ADF, or None).
BRG2
The BRG2 soft key cycles through the available bearing 2 indicator modes
(NAV2, GPS2, ADF, or None). This soft key will only be present if the system
is configured for a second GPS or VOR/LOC.
SYN VIS
The SYN VIS soft key is available if Synthetic Vision Technology™ is installed.
It enables Synthetic Vision and displays the associated soft keys.