Pilot's Guide

4-22
Garmin G500H Pilot’s Guide
190-01150-02 Rev. F
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
Traffic Advisory,
Off Scale Aircraft
is Out of Range,
1200 ft Above and
Climbing
Operating
Mode
Traffic Advisory,
Aircraft is 1200 ft
Above and Climbing
Range Ring Diameter
Non-Threat
Traffic
Proximity Advisory,
1200 ft Above and
Climbing
Non-Bearing Traffic (System is Unable to
Determine Bearing), Aircraft Distance is
8.0 NM, 1100 ft Above and Descending
Ownship
Symbol
Figure 4-24 Traffic Map Page - TAS
4.6.1.1 Switching from Standby Mode to Operating Modes
The unit must be in operating mode for traffic to be displayed. The ability
to switch from standby to operating mode on the ground is especially useful for
scanning the airspace around the airport before takeoff.
1) While viewing the Traffic page of the MAP page group, select the OPERATE soft
key or press the MENU key and turn the small MFD knob to select Operating
Mode.
2) To switch to Standby Mode from the Traffic Page, select the STANDBY soft
key.
3) Select the ALT MODE soft key to change the altitude volume.
4) Select the STANDBY soft key to place the system in the Standby mode.
STANDBY is displayed in the Traffic mode field.
NOTE: Not all TAS systems can be controlled from the G500H. The Operate/
Standby soft keys may not be displayed. An alert will be generated when
Standby is selected and the aircraft is in the air.