Pilot's Guide

3-46
Garmin G500H Pilot’s Guide
190-01150-02 Rev. F
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
3.4.1.2 Airspeed Reference Marks
The airspeed reference marks for the PFD are adjusted with this function.
A marker will appear on the PFD Airspeed tape at the selected speed when the
value is set to “On.” Default reference airspeeds are set during installation. When
power is cycled, the values you set will be reset.
NOTE: When power is cycled, the Airspeed Reference values are reset.
During preflight, the Airspeed Reference values should be checked and
set appropriately for the current aircraft configuration and performance.
Figure 3-70 Airspeed References shown on PFD when activated
1) While viewing the System Setup page of the AUX page group, press the small
MFD knob to activate the cursor. Turn the large MFD knob to highlight the
desired Airspeeds value.
2) Turn the small MFD knob to select the value and press ENT .
3) The On/Off setting will now be highlighted. Turn the small MFD knob to select
On or Off and press ENT . The next value will be highlighted.