Instruction Manual

Instructions for Continued Airworthiness 190-00792-12 Rev 1
for the Garmin G500H Installation in Eurocopter AS350 Page 23 of 80
e) Terminal Block Installation
Terminal Block is located underneath the cabin floor between station 1120 and 1502 on
the left side of the aircraft. (Figure 6-05)
Access Removal and Installation Methods
i. Removal
1. Un-latch the Center lower belly access panel.
2. Disconnect the retaining straps that prevent the panel from falling to the floor.
3. If aftermarket items are attached to the Center lower belly panel it may be
necessary to remove or disconnect them in order to remove the lower belly panel.
Consult the manufacturers Installation and Removal instructions for proper
removal of items.
ii. Installation
1. Re-install aftermarket items if removed to gain access to the air data computer.
Consult the manufacturers Installation and Removal instructions for proper
installation of items.
2. Connect the retaining strap that was disconnected to gain access to the air data
computer.
3. Close the Center lower belly access panel and latch it.
Caution: Use of power tools during removal or installation of
panels and attaching hardware may damage nut plates or
deform holes in composite doors, covers, panels, and fairings.
06-00-00
Figure 6-05
Terminal Block
STA
1120
REF
STA
1502
REF