Instruction Manual

Instructions for Continued Airworthiness 190-00792-12 Rev 1
for the Garmin G500H Installation in Eurocopter AS350 Page 19 of 80
CHAPTER 6
Section 06-00-00 Dimensions and Access
1. Access Methods
For removal and installation of specific components, reference Section 31-00-00 Instruments,
Removal and Replacement
a) GMU 44, Magnetometer
Magnetometer is located in the tail boom between TB 868 and 1578. (Figure 6-01)
Access Removal and Installation Methods
i. Removal
1. Un-latch and open the baggage compartment door on the left side of the aircraft.
2. Remove the tail boom closeout panel by loosening the ¼ turn fasteners that hold it
in place.
3. If an air conditioner is installed it may be necessary to remove the air conditioner
unit to gain access to the magnetometer. Consult the manufacturers Installation
and removal instructions for proper removal of unit.
ii. Installation
1. Re-install air conditioner if removed to gain access to the magnetometer. Consult
the manufacturers Installation and Removal instructions for proper installation of
unit.
2. Re-install tail boom closeout panel by tightening the ¼ turn fasteners that hold it in
place.
3. Close the baggage compartment door and latch it.
Caution: Use of power tools during removal or installation of
panels and attaching hardware may damage nut plates or
deform holes in composite doors, covers, panels, and fairings.
06-00-00
Figure 6-01
TB
868
REF
TB
1578
REF
GMU 44