Instruction Manual

500W Series 190-01226-03 Rev. 2
Instructions for Continued Airworthiness Bell 206B Page 14 of 22
Alert Text Possible Cause Solution
Data transfer cancelled
(version mismatch)
• An attempt to transfer data
during a unit-to-unit crossfill
was cancelled. The database
versions of the two 500W-
series unit are not identical.
• If necessary, update the
database(s) so they
match.
Data transfer error, please
re-transmit
• An error was detected during
unit-to-unit crossfill of user
data (user waypoints and/or
flight plans).
• The data transfer should
be re-attempted.
Display backlight failure
• The 500W Series unit has
detected a failure in the display
backlighting.
• Contact Garmin technical
support.
Do not use for navigation
• The 500W Series unit is in
Demo Mode and must not be
used for actual navigation.
• Check that the DEMO
MODE SELECT pin is not
connected. See Section
4.5.1.12.
G/S has failed
(530W only)
• The unit has detected a failure
in its glideslope receiver.
• Contact Garmin technical
support.
G/S is not responding
(530W only)
• Internal system-to-system
communication between the
main processor and the
glideslope receiver has failed.
Operational status of the
glideslope receiver is
unknown.
• Contact Garmin technical
support.
G/S needs service
(530W only)
• The unit has detected a failure
in its glideslope receiver. The
glideslope receiver may still be
usable.
• Contact Garmin technical
support.
GAD configuration required
• The GAD 42 Interface Adapter
has lost the configuration
information stored in its
internal memory. Any
mechanical indicators
connected to your 500W-
series unit are unusable.
• Reconfigure the GAD 42
unit. Refer to the GAD 42
Installation Manual
(P/N 190-00159-00)
GAD needs service
• The 500W Series unit has
detected a failure in the
GAD 42 interface adapter.
Any mechanical indicators
connected to your unit are
unusable.
• Refer to Section 5.2.3 of
the GAD Installation
Manual (P/N 190-00159-
00)
• Check for proper
configuration
• Check wiring
GDL 69 is not responding
• No data is being received from
the GDL 69.
• Contact Garmin technical
support.