Pilot's Guide

2-31190-00601-02 Rev. H
Garmin G500/600 Pilot’s Guide
CoverTOC
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
2.8.6 Miscompare Annunciations
Miscompare annunciations are capable of being displayed on the PFD if the
miscompare Monitor is enabled during the installation configuration.
Messages will appear in the MFD alerts window if monitors are enabled and
required data is not present.
A miscompare condition is triggered if the difference between the data
reported by GDU 1 and GDU 2 exceeds the threshold described in the following
table for at least one second:
Parameter Range of Trigger Threshold
Altitude ALL 200 feet
Indicated Airspeed Both IAS < 35 kts Inhibited
Indicated Airspeed Either IAS >= 35 kts 10 kts
Indicated Airspeed Either IAS >= 80 kts 7 kts
Pitch ALL 5 degrees
Roll ALL 6 degrees
Table 2-3 Miscompare Conditions
A “MISCOMP” annunciation is displayed on the airspeed tape if a miscompare
condition exists for indicated airspeed. A “MISCOMP” annunciation is displayed
on the altitude tape if a miscompare condition exists for altitude. A “PITCH
MISCOMP” annunciation is displayed over the pitch ladder if a miscompare
condition exists for pitch and not roll. A “ROLL MISCOMP” annunciation is
displayed over the pitch ladder if a miscompare condition exists for roll and
not pitch. An “ATTITUDE MISCOMP” annunciation is displayed over the pitch
ladder if a miscompare condition exists for both pitch and roll.