Pilot's Guide

4-63190-00601-02 Rev. H
Garmin G500/600 Pilot’s Guide
CoverTOC
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
4.8.7 NEXRAD Data Viewing Range
The NEXRAD Viewing Range option allows you to select the map range
where at and below the selected value NEXRAD weather products will be shown
on the selected MFD Wx Data Link Map page (1, 2, or 3). When Off is selected,
NEXRAD weather data will not be shown. For the value (such as 100 NM) that
is selected, NEXRAD data will be shown at the selected map ranges (such as 100
NM) and lower.
1) While viewing a WX Data Link Map page of the WX page group, press the
MENU key to display the Page Menu Options . The cursor flashes on the
“Weather Setup” option. Press ENT .
2) Turn the small MFD knob to select “Weather Setup 1/2” and press ENT.
3) Turn the large MFD knob to highlight he NEXRAD Data Viewing Range value.
Turn the small MFD knob to highlight the desired value.
4) Press ENT to accept the displayed value. The next option will be highlighted.
5) Press the small MFD knob to cancel selection or to end editing and return to
the previously viewed page or turn the large MFD knob to the next option.
4.8.8 NEXRAD Legend
The NEXRAD Legend selection provides the option of displaying an
abbreviated version of the NEXRAD legend in the top right region of the MFD.
The full legend is available by pressing the LEGEND soft key.
Figure 4-41 NEXRAD Legend Selection
1) While viewing Weather Setup 1/2 menu, turn the large MFD knob to highlight
the NEXRAD Legend value.
2) Turn the small MFD knob to highlight Off or On. Press ENT to accept the
displayed value. The next option will be highlighted.
3) Press the small MFD knob to cancel selection or to end editing and return to
the Navigation Map page or turn the large MFD knob to the next option.