Pilot's Guide

3-33190-00601-02 Rev. H
Garmin G500/600 Pilot’s Guide
CoverTOC
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
4) With the Mode value highlighted, turn the small MFD knob to select Auto or
Manual and then press ENT .
Figure 3-40 Aux Mode Display Brightness Mode Selection
3.2.1.2 Airspeed Reference Marks
The Best Glide (or REF), Vr, Vx (or V1), and Vy (or V2) airspeed reference
marks for the PFD are adjusted with this function. A marker will appear on the
PFD Airspeed tape at the selected speed when the value is set to “On.” Default
reference airspeeds are set during installation. When power is cycled, the values
you set will be reset to the default values.
NOTE: When power is cycled, the Airspeed Reference values are reset.
During preflight, the Airspeed Reference values should be checked and
set appropriately for the current aircraft configuration and performance.
Figure 3-41 Airspeed References shown on PFD when activated