Pilot's Guide

3-32
Garmin G500/600 Pilot’s Guide
190-00601-02 Rev. H
Cover TOC
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
The default values set by the installer during installation are restored by using
the Page Menu options or soft keys. The “Restore Unit Defaults” menu selection
and the DFLT UNIT soft key restores the default MFD Display and System
Display Units settings. The “Restore Airspeed Defaults” menu selection or DFLT
SPD soft key restores the default PFD Airspeeds settings.
The RA TEST soft key activates the Radar Altimeter test mode. See the Radio
Altimeter section in Section 2 for details.
NOTE: Not all Radar Altimeters have the TEST function.
1) While viewing the Aux mode System Setup page, press the MENU key.
Figure 3-38 Aux Mode System Setup Page Menu
2) Turn the large or small MFD knobs to highlight the desired selection and then
press ENT .
3.2.1.1 Display Brightness
Display brightness mode may be set to manual or automatic. The automatic
mode will set the display brightness based on the ambient light. The manual
mode allows the setting of display brightness between 0 and 100%.
1) Turn the large MFD knob to reach the AUX page group. Press the small MFD
knob to activate the cursor.
2) The Level will be highlighted. Turn the small MFD knob to select the Display
Brightness Level and then press ENT .
Figure 3-39 Aux Mode Display Brightness Level Selection
3) If the Level was changed, Manual will be selected. Press the cursor to save the
settings. If you press ENT the Mode setting will be highlighted.