Instruction Manual

400W Series P/N 190-00356-65 Rev. D
Instructions for Continued Airworthiness Page 9 of 12
2.7.2 Flight Stream 210 (If Installed)
See Figure 1 when performing the following steps:
Removal
1. Locate and open the BT Link circuit breaker.
2. Unscrew the two jackscrews on the Flight Stream 210 connector. Remove connector.
3. Remove the four #6 mounting screws to remove the Flight Stream 210.
Reinstallation
1. Check that the BT Link circuit breaker is open.
2. Reinstall the Flight Stream 210 using the four previously removed #6 mounting screws.
3. Tighten fasteners until snug, plus an additional 1/4 turn.
Note: Ensure that the Flight Stream 210 is mounted with the arrow pointing in the direction of flight.
4. Attach the connector, tightening the two jackscrews.
5. Close the B/T Link circuit breaker.
6. Complete the interface checkout procedures contained in Section 5.5.7 of the 400W Series
Installation Manual.
Figure 1. Flight Stream 210 Assembly Overview (Bonding Strap Not Shown)