User Guide

190-00443-01 Rev. A Garmin G1000 PFD Pilot’s Guide for Mooney M20M & M20R
3-47
SUPPLEMENTAL FLIGHT DATA
Select Departure
Select Departure allows the pilot to choose a published
standard instrument departure (SID) for the departure air
-
port, or replace the current departure with a new selection.
When using a direct-to, the G1000 uses the nearest airport
as a reference when displaying available departures.
NOTE: The pilot may also select an approach, an
arrival and a departure by pressing the MENU
key.
To select a departure for the departure
airport:
1. From an active flight plan, press the
PROC key
to display the Procedures options window.
2. Turn the
large FMS knob to highlight ‘Select
Departure’, then press the ENT key. A window
appears listing the available departures for the
departure airport.
3. Turn the
FMS knob to select the desired depar-
ture, then press the
ENT key.
NOTE: This runway window is not displayed for
every departure. ‘ALL’ may appear in the runway
field, indicating that the departure procedure
applies to all runways. For airports with parallel
runways, ‘B’ may appear at the end of the runway
designation to indicate that the departure pro
-
cedure applies to both runways.
4. A window may appear listing runways for the
departure. Turn the
FMS knob to select the
desired runway, then press the
ENT key. The
transition window is now displayed.
5. Turn the
FMS knob to select the desired tran-
sition, then press the
ENT key. With ‘LOAD?’
highlighted, press the
ENT key.
Activate Approach
Activate Approach allows the pilot to activate the ap
-
proach when ready to begin navigating the approach
course (cleared for the approach).
To activate the approach for a direct-to or
flight plan destination airport:
1. From an active flight plan, press the
PROC key
to display the Procedures options window.
2. Turn the
large FMS knob to highlight ‘Activate
Approach’, then press the
ENT key.
Activate Vector-To-Final
Activate Vector-To-Final allows the pilot to activate the
final course segment of the approach. This option assumes
that the pilot will receive vectors to the final approach fix
(FAF) and provides guidance to intercept the final course,
before reaching the FAF.
To activate the approach with vectors to
final:
1. From an active flight plan, press the
PROC key
to display the Procedures options window.
2. Turn the
FMS knob to highlight ‘Activate Vector-
To-Final’, then press the
ENT key.