User Guide

190-00443-01 Rev. AGarmin G1000 PFD Pilot’s Guide for Mooney M20M & M20R
3-46
SUPPLEMENTAL FLIGHT DATA
Select Arrival
Select Arrival allows the pilot to choose a published
standard terminal arrival route (STAR) for the destination
airport, or replace a current arrival with a new selection.
NOTE: The pilot may also select an approach,
arrival and departure by pressing the MENU
key.
To select an arrival for a direct-to or flight
plan destination airport:
1. From an active flight plan, press the
PROC key
to display the Procedures options window.
2. Turn the
large FMS knob to highlight ‘Select
Arrival’, then press the
ENT key. A window
appears listing the available arrivals for the
destination airport.
3. Turn the
FMS knob to select the desired arrival,
then press the
ENT key. A window appears
listing the available transitions for the arrival.
4. Turn the
FMS knob to select the desired transi-
tion, then press the
ENT key.
NOTE: This runway window is not displayed for
every arrival. ‘ALL’ may appear in the runway
field, indicating that the arrival procedure applies
to all runways. For airports with parallel runways,
‘B’ may appear at the end of the runway designa
-
tion to indicate that the arrival procedure applies
to both runways.
5. A window may appear listing runways for the
arrival. Turn the
FMS knob to select the desired
runway, then press the
ENT key. With ‘LOAD?’
highlighted, press the ENT key.
NOTE: When adding an arrival to an active flight
plan, the pilot may need to remove a duplicate
destination waypoint from the flight plan list.
Figure 3.6.29 Arrival
Figure 3.6.30 Arrival Transition
Figure 3.6.31 Arrival Runway
Figure 3.6.32 Select Arrival Window