User Guide

190-00443-01 Rev. A Garmin G1000 PFD Pilot’s Guide for Mooney M20M & M20R
3-45
SUPPLEMENTAL FLIGHT DATA
Select Approach
Select Approach allows the pilot to choose a published
instrument approach for the destination airport, or replace
the current approach with a new selection.
NOTE: The pilot may also select an approach, an
arrival and a departure by pressing the MENU
key.
To select an approach for a direct-to or
flight plan destination airport:
1. From an active flight plan, press the
PROC key
to display the Procedures options window.
2. Turn the
large FMS knob to highlight ‘Select
Approach’, then press the
ENT key. A window
appears listing the available approaches for
the destination airport.
3. Turn the
FMS knob to select the desired
approach, then press the
ENT key. A window
appears listing the available transitions for the
approach.
NOTE: The ‘Vectors’ option assumes that the pilot
will receive vectors from ATC to the final course
segment of the approach.
4. Turn the FMS knob to select the desired transi-
tion or vectors, then press the ENT key. With
‘LOAD?’ highlighted, press the
ENT key to load
the approach.
5. To activate the approach, turn the
large FMS
knob to highlight ‘ACTIVATE?’, then press the
ENT key.
NOTE: ‘LOAD’ adds the approach to the flight
plan without immediately using the approach
for navigation guidance. This allows the pilot
to continue navigating the original flight plan
until cleared for the approach, but keeps the
approach available for quick activation when
needed. ‘ACTIVATE’ adds the approach to the
flight plan and begins navigating the approach
course.
Figure 3.6.26 Approach
Figure 3.6.27 Approach Transition
Figure 3.6.28 Select Approach Window