User Guide

190-00443-01 Rev. A Garmin G1000 PFD Pilot’s Guide for Mooney M20M & M20R
3-23
FLIGHT INSTRUMENTS
Radio Tuning Window
The Radio Tuning window is displayed by pressing the
ADF/DME (ADF, DME, or ADF/DME depending on the
installation) softkey. This window provides display and
control of single or dual ADF and DME radio(s). Depend
-
ing on the installation, the Radio Tuning window may be
titled ADF Tuning, DME Tuning, or ADF/DME Tuning.
There are two ADF frequency fields, the active field (green)
on the left and the standby field (white) on the right.
NOTE: The Radio Tuning window is only available
if the DME and/or ADF radios are installed.
Figure 3.4.24 Radio Tuning Window
To edit the standby ADF frequency:
1. From the Radio Tuning window with the
standby ADF frequency highlighted, turn the
small FMS knob to place the cursor on the first
digit.
2. Turn the
FMS knobs to enter the desired fre-
quency and press the ENT key. The standby
frequency is now highlighted.
3. Press the
ENT key again to transfer the standby
frequency to the active frequency field.
NOTE: The ENT key is used to transfer the ADF
standby and active frequency whenever the
cursor is highlighting a standby frequency.
NOTE: Each time the cursor is on the ADF standby
frequency, and the standby frequency is not in
“edit” mode, the “ENT TO TRANSFER” message
is displayed at the bottom of the Radio Tuning
window to assist the pilot in performing the
transfer.
To change the ADF mode:
1. From the Radio Tuning window, turn the
large
FMS knob to highlight the ADF mode field.
2. Turn the
small FMS knob in the direction of the
green arrow(s) to select the desired mode of
operation.
To change the ADF volume:
1. From the Radio Tuning window, turn the
large
FMS knob to highlight the volume field.
2. Turn the
small FMS knob to the left to decrease
the volume. Turn the small FMS knob to the
right to increase the volume.
To change the DME mode:
1. From the Radio Tuning window, turn the
large
FMS knob to highlight the DME mode field.
2. Turn the
small FMS knob to display the selec-
tion window. Turn the
FMS knob to select the
desired mode and press the ENT key.
Figure 3.4.25 DME Selection Window