User Guide

Garmin G1000 MFD Pilot’s Guide for the Mooney M20M & M20R190-00448-00 Rev. A
8-83
PROCEDURES
Vectors to the DME ARC
In this example you are enroute from KSAF to KFMN
on a heading of 294°, 25 miles out and ATC is giving you
vectors to intercept the arc outbound from HIDOX.
1. Activate the approach.
2. ATC instructs the pilot to turn left to a heading
of 270° to intercept the arc.
3. Prior to intercepting the arc the leg must be
activated since the arc was not intercepted at
the IAF.
4. With the Active Flight Plan page displayed,
press the FMS knob to activate the cursor.
5. Turn the
large FMS knob to highlight DME ARC
and press the ‘ ACT LEG ’ softkey.
6. A confirmation window appears with ‘ACTI
-
VATE’ highlighted, press the
ENT key. This
activates the arc leg as well as the approach.
7. Follow the arc, keeping the CDI needle cen
-
tered.
8. The next point in the approach is an intermedi
-
ate fix WILDE. As the pilot approaches WILDE
a waypoint message ‘NEXT DTK 072°’ appears.
As the distance to this fix approaches zero the
message is replaced by a turn advisory ‘TURN
TO 072°’. Initiate a standard rate turn to this
course heading.
9. At 2.0 nm from the FAF (PINTO), the G1000
switches from terminal mode to 0.3 nm. CDI
scaling begins rounding down from 1.0 to 0.3
nm, full scale deflection.
10. As the pilot approaches the FAF, a waypoint
message ‘NEXT DTK 072°’ appears. Make any
adjustments necessary for the final course seg
-
ment (FAF to MAP).
11. Upon crossing the FAF, the destination
sequences to the MAP (RW07map, the runway
threshold). Keeping the CDI needle centered,
fly toward the MAP, observing the altitude
minimums dictated by the approach plate.
12. As the pilot approaches the MAP, a waypoint
message ‘ARRIVING AT WAYPOINT’ appears.
13. Upon crossing the MAP, ‘SUSP’ appears on the
HSI and directly above the
OBS softkey, indi-
cating that automatic sequencing of approach
waypoints is suspended. A FROM indication is
displayed on the CDI, however course guidance
along the final approach course continues.
Do NOT follow this extended course. Follow
the published missed approach procedures
using the SUSP softkey to initiate the missed
approach sequence.