User Guide

Garmin G1000 MFD Pilot’s Guide for the Mooney M20M & M20R 190-00448-00 Rev. A
8-140
AUXILIARY PAGE GROUP
Pilot Profiles
The Pilot Profile section of the System Setup Page
allows the pilot to select, create, delete, and rename up
to a total of 25 profiles. Profiles can be created based on
Garmin Factory Defaults, Default Profile Settings, Current
System Settings, and Custom Profile Settings.
The Pilot Profile section of the system setup page dis
-
plays the following data:
• The current active profile
• Number of profiles slots used
• Number of profile slots available
Selecting the Active Profile
To select an active profile:
1. Select the System Setup Page.
2. Press the
FMS knob momentarily, to activate
the flashing cursor.
3. Turn the
large FMS knob to highlight the
ACTIVE field in the Pilot Profile box.
4. Turn the
small FMS knob to display the pilot
profile list.
5. Turn the
small or large FMS knobs to highlight
the desired pilot profile.
6. Press the
ENT key. The G1000 loads and
displays the system settings for the selected
profile.
NOTE: Pilot profile names cannot start with a
blank as the first letter in the name
Creating a Profile
To create a Profile:
1. Select the System Setup Page.
2. Press the
FMS knob momentarily, to activate
the flashing cursor.
3. Turn the
large FMS knob to highlight the
CREATE field in the Pilot Profile box.
4. Press the
ENT key.
5. Turn the
small and large FMS knobs to enter
a profile name. Up to 16 letters and numbers
can be used.
6. Once the profile name is entered, press the
ENT
key.
7. The cursor moves to the CURRENT SETTINGS
field. If you want the new pilot profile based
on the current system settings press the
ENT
key.
8. If you want the new pilot profile to be based
on other settings, turn the
small FMS knob to
display the settings list.
9. Turn the
small or large FMS knobs to highlight
the desired settings and press the ENT key.
10. The cursor moves to the CREATE field. Press
the ENT key to create a profile. To cancel the
profile, turn the
large FMS knob to highlight
the CANCEL field and press the ENT key. To
create and activate the profile turn the large
FMS
knob to highlight the CREATE & ACTIVATE
field and press the
ENT key.
