User Guide

Garmin G1000 MFD Pilot’s Guide for the Mooney M20M & M20R190-00448-00 Rev. A
8-129
AUXILIARY PAGE GROUP
7. The flashing cursor moves to the fuel on board
field. Turn the small and large FMS knobs to
modify the fuel on board. Press the
ENT key
when finished. Note that in automatic mode
this is provided by the system.
8. The flashing cursor moves to the calibrated
airspeed field. Turn the
small and large FMS
knobs to enter an calibrated airspeed. Press
the ENT key when finished.
With all variables entered, the following information is
provided (all of the items are not available at all times):
• Efficiency
• Total Endurance
• Remaining Fuel
• Remaining Endurance
• Fuel Required
• Total Range
Other Statistics
To calculate Density Altitude and True Air-
speed
1. Select ‘MANUAL’ page mode by pressing the
Manual softkey.
2. Turn the
large FMS knob to select the ‘IND
ALTITUDE’ field. Turn the small and large FMS
knobs to enter the altitude indicated on your
altimeter. Press the
ENT key when finished.
3. The flashing cursor moves to the ‘PRESSURE’
field. Turn the
small and large FMS knobs to
enter the barometric pressure (altimeter set-
ting). Press the
ENT key when finished.
4. The flashing cursor moves to the total air tem
-
perature (‘TAT’) field. ‘TAT’ is the temperature,
including the compressibility error heating of
speed, read on the outside air temperature
gauge located in the lower left corner of the
PFD. Turn the small and large FMS knobs to
enter the temperature. Press the
ENT key when
finished.